Ram 2500 near San Jacinto, California

Ram 2500: the full picture

Among three-quarter-ton pickups the Ram 2500 competes on something its rivals largely do not offer: how it feels when the bed is empty. Ford and Chevrolet use leaf springs at the rear. Ram uses coil springs, with an air suspension available, and the difference is obvious the first time you drive an unladen truck over a broken surface.

Whether that matters depends on your week. A truck that spends its life loaded barely benefits, because every heavy-duty pickup rides acceptably with weight in the back. A truck that runs empty between sites — which describes an enormous number of contractor vehicles in Riverside and San Bernardino counties, where an hour each way is unremarkable — benefits every single day.

The engine choice frames everything else. The petrol V8 is the sensible default for a truck doing local work with intermittent towing: cheaper to buy, cheaper to service, and immune to the diesel after-treatment problems that short trips cause. The Cummins inline-six is the reason many buyers come to Ram at all, and it is genuinely well regarded, but it only pays back on sustained towing and high annual mileage.

That Cummins reputation deserves a note of realism. It is a durable engine with a strong following, and used Cummins trucks hold value accordingly. It is also a substantial purchase premium and a more expensive engine to service, and modern emissions equipment applies to it as much as to anything else. Buy it for the duty cycle, not for the badge.

For fleet buyers, the Tradesman trim is the relevant one. It strips the truck to vinyl floors, basic seating and the equipment that actually earns money, which lowers both the purchase price and the cost of a damaged interior. It is the trim most Southern California contractors should be looking at, and the one least often on a dealer forecourt because showrooms prefer to stock the profitable ones.

The 2500 also sits at a useful regulatory point. At roughly 10,000 to 11,000 lbs GVWR it is a straightforward vehicle to licence, insure and staff, and it does not push you towards the thresholds that begin to complicate matters at one-ton and above. For a business that needs real capability without regulatory friction, that is a meaningful part of the appeal.

How businesses actually use it

How to choose the right configuration

Start with payload rather than towing, because payload is where three-quarter-ton buyers get caught. A service body, a full toolkit, fuel and two people can consume most of a 2,900 lb rating before you have loaded any materials. Add up what permanently lives in the truck first, and only then ask what you want to put in it.

Choose the engine by annual mileage and towing hours, not by preference. If you tow heavy several days a week or cover high mileage, the Cummins earns its premium in fuel, torque and resale. If you do local work with occasional towing, the petrol V8 costs less to buy, less to service, and avoids the regeneration problems that short urban trips cause diesels.

Take the coil-spring suspension seriously, in both directions. It genuinely improves unladen ride, which is worth real money on long empty runs. It also behaves differently under load than leaf springs, and drivers moving from a Ford or Chevrolet should expect that rather than be surprised by it. If air suspension is offered on the truck you are considering, understand it as an additional system to maintain as well as a benefit.

Be honest about whether you need the 3500 instead. The gap between them is mostly rear axle and payload, and buyers who tow goosenecks or carry heavy permanent bodies are usually better served one step up. Conversely, plenty of businesses buy a 3500 for towing they do four times a year and pay for it every other day.

Look specifically for Tradesman and other fleet trims when buying used. They are the trucks that were bought to work, they usually cost less than an equivalent higher trim, and a vinyl floor survives a decade of work boots in a way carpet does not. The catch is that dealers stock fewer of them, so they take longer to find.

Finally, check your local service arrangements before committing to a Cummins. Diesel servicing is more specialised and the network for it is thinner than for petrol engines in parts of the Inland Empire. A cheaper truck that takes a week to get looked at is not actually cheaper.

Our assessment

An editorial evaluation written by the SoCal Work Trucks editorial team, last reviewed 2026-09-04. It is our own assessment, not customer reviews or ratings.

The most comfortable heavy-duty pickup to drive empty, which is a genuine advantage for crews covering Southern California distances between sites. Capability is competitive rather than class-leading, and the Cummins is excellent but only pays back on real towing hours. Buy the Tradesman with the petrol V8 for local work, the Cummins for sustained towing, and be honest about which of those you actually do.

Questions buyers ask

Why does the Ram 2500 ride better than a Ford or Chevrolet?

Because it uses coil springs at the rear rather than leaf springs, with air suspension available on some configurations. The difference is most obvious with an empty bed over broken surfaces. Loaded, every heavy-duty pickup improves, so the advantage matters most to trucks that run empty between sites.

Is the Cummins diesel worth the extra cost?

It depends on hours towing and annual mileage. Tow heavy several days a week or cover high mileage and it repays in torque, economy and resale. Do local work with occasional towing and the petrol V8 is the better business decision, because short trips are exactly where diesel after-treatment causes downtime.

How much can a Ram 2500 carry?

Payload typically runs around 2,900 to 4,000 lbs depending on cab, drivetrain and engine. The diesel is heavier than the petrol engine and reduces payload accordingly, which surprises buyers who assume the more capable engine means the more capable truck. Check the door placard on the specific vehicle.

What is the Tradesman trim?

Ram's work-focused trim: vinyl floors, basic seating and the equipment a working truck needs, without showroom features. It costs less to buy and copes better with tools and boots over a decade. It is the trim most contractors should want and the one dealers stock least, so expect to search for it used.

Should I buy a 2500 or a 3500?

The 2500 if you tow conventionally and carry moderate loads; the 3500 if you tow goosenecks, carry a heavy permanent body, or regularly find yourself near the rating. Calculate what lands on the rear axle rather than what the trailer weighs, because that is the number that decides it.

How much can a Ram 2500 tow?

Up to roughly 20,000 lbs on the right configuration, with most trucks rated well below that. Cab, engine, axle ratio and hitch type all change the figure substantially, so treat headline numbers as a ceiling for one specification and check the towing guide for the truck you are actually buying.

Does the air suspension cause problems?

It is an additional system, so it is an additional thing to maintain, and on a high-mileage truck that has worked hard it is worth inspecting carefully. That said, it is not a known weak point in normal service. Exercise it through its full range during inspection and listen to the compressor.

Is diesel servicing easy to find in the Inland Empire?

Less so than petrol servicing, particularly away from the main corridors. It is not a reason to avoid a Cummins, but it is a reason to identify your service provider before you buy rather than after. Downtime waiting for a specialist appointment is a real operating cost.

What should I check on a used Ram 2500?

Service records first, especially on a Cummins. Then rear coil springs and shock mounts for sag, the stance of the bed relative to the cab, and the air suspension through its full travel if fitted. A truck that has lived permanently overloaded shows it in how it sits before anything else gives it away.

How does the Ram 2500 hold its value?

Cummins-equipped trucks hold value strongly, helped by the engine reputation and steady demand on the used market. Petrol trucks depreciate more conventionally. A documented service history matters more on this model than most, precisely because buyers are paying for the engine and want evidence it was looked after.

Can a Ram 2500 take a service body?

Yes, and it is a common configuration for mobile trades. The constraint is payload rather than fitment: a steel body is heavy before you add tools, parts and fuel. Weigh the finished truck, and if the numbers are tight, specify the 3500 rather than running at the rating every day.

How does the Ram 2500 handle Southern California heat when towing?

Sustained grades in summer heat are the hardest thing you can ask of any heavy-duty pickup, and the Cajon Pass and the grades out towards Palm Springs are exactly that. Both engines are engineered for it, but cooling system condition is what actually determines whether a truck copes, which makes it a priority inspection item on anything used. Check coolant condition and service history, look for evidence the radiator and intercooler have been kept clean rather than packed with dust and insects, and be realistic that a truck towing near its rating uphill in August will run hotter and use considerably more fuel than any published figure suggests.

Is four-wheel drive worth it for Southern California work?

For most urban and suburban trades, no. Paved sites, dry weather and a loaded rear axle mean two-wheel drive is sufficient nearly all the time, and skipping four-wheel drive saves purchase cost, saves weight that comes straight off your payload, and removes a drivetrain to maintain. It becomes worth having if you regularly access unpaved or graded sites, work agricultural land, or run in soft material such as sand or fresh fill, all of which are common enough inland that plenty of contractors specify it. Decide on the sites you actually visit rather than on the possibility of one difficult day a year.

Is the Mega Cab worth considering for work?

Rarely, for most trades. It trades bed length for rear cabin space, which suits crews who travel far and carry little, but it makes the truck longer to park and reduces the bed you have left to work with. For most contractors a Crew Cab with a full bed is the more useful configuration, and it is easier to sell on.

Official sources and further reading

Manufacturer and regulatory sources for specifications and requirements. We do not link to other vehicle-selling websites.

• Ram ProfessionalRam’s commercial division: chassis cabs, ProMaster and BusinessLink support.
• California DMV — Vehicle Industry ServicesDealer licensing, registration and commercial vehicle requirements in California.
• FMCSA — Commercial Driver’s License requirementsFederal rules on when a CDL is required — the reason GVWR above 26,001 lbs changes who can drive the truck.
• CARB — Advanced Clean FleetsCalifornia Air Resources Board programme affecting commercial fleet vehicle purchases in this state.
• NHTSA safety ratingsOfficial crash-test and safety information by make, model and year.